InFeeo
Global
technology
New
Language
@James
Profile channel

@James

No bio yet.

Since 30.05.2026

Why a Direct, 500 Mbit Tailscale Link Only Gave Me 10 Mbit for One Stream(tailscale.com)
The Problem My self-hosted Jellyfin was slow whenever I connected to it from abroad over Tailscale. My ISP upload is about 500 Mbit/s, but streams stuttered and iperf3 over the tunnel only managed ~10 Mbit/s: $ iperf3 -c jellyfin-host [ 5] 0.00-10.00 sec 11.9 MBytes 10.0 Mbit/s It wasn’t a relay or routing issue — tailscale status showed a direct connection (not a DERP relay): $ tailscale status 100.xx.xx.xx jellyfin-host linux active; direct xx.xx.xx.xx:41641 So: direct, low-latency, half a gigabit of upload available — and still only 10 Mbit/s for a single stream.
Made a tool so I stop rewriting tactile sensor loaders every project(reddit.com)
https://reddit.com/link/1u0rx4y/video/yhckg2drz56h1/player Sick of writing custom parsers every time I switch tactile sensors. Threw this together — one API, any sensor, 3 lines. Video shows the useful thing: demo: AI pre-annotate → review → export. Took me like 2 minutes. pip install tlabel import tlabel tlabel.demo() # try it right now, zero config Works with GelSight Mini, DIGIT, PaXini, Daimon. MIT, free. submitted by /u/ImmediateArm7942 [link] [Kommentare]